Jump to content


Photo

Getting started with the EFX room reverb system (wip)

sound openal efx reverb delay tutorial

55 replies to this topic

#51 grayman

grayman

    Master Builder, Coder

  • Active Developer
  • PipPipPipPipPip
  • 12922 posts

Posted 10 March 2019 - 07:32 AM

I was using 2.07.

#52 stgatilov

stgatilov

    Lead Programmer

  • Active Developer
  • PipPipPip
  • 1707 posts

Posted 17 March 2019 - 10:54 AM

IIRC, in last update EFX values were updated to use the actual EFX standard. Before 2.07, they used TDM or Doom3 specific values which had different ranges.

The update takes effect only if you set Version 2 in the preamble.

If you use Version 1, then old (original) rules are used.

 

UPDATE: Maybe add a note about Version 2 and new presets in the original post?


  • VanishedOne likes this

#53 grayman

grayman

    Master Builder, Coder

  • Active Developer
  • PipPipPipPipPip
  • 12922 posts

Posted 17 March 2019 - 11:59 AM

I'll continue to use Version 1 until the Version 2 templates become available.



#54 stgatilov

stgatilov

    Lead Programmer

  • Active Developer
  • PipPipPip
  • 1707 posts

Posted 18 March 2019 - 08:32 AM

I'll continue to use Version 1 until the Version 2 templates become available.

The Version 2 has some built-in presets: they are defined by OpenAL-Soft.

Here is the section about it.

 

On the other hand, you can of course continue using Version 1 definitions.


  • Judith likes this

#55 Judith

Judith

    Advanced Member

  • Member
  • PipPipPip
  • 1984 posts

Posted 18 March 2019 - 10:23 AM

I've been using some of the Version 2 presets too, they seem to work fine.

#56 grayman

grayman

    Master Builder, Coder

  • Active Developer
  • PipPipPipPipPip
  • 12922 posts

Posted 18 March 2019 - 10:11 PM

I switched WS5 to Version 2, and the presets appear to work just fine.


  • stgatilov and Anderson like this



Reply to this topic



  



Also tagged with one or more of these keywords: sound, openal, efx, reverb, delay, tutorial

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users