Walls and rooms gone invisible/black

[Duke Lebowski]

Hey guys,

 

So i have an issue that keeps happening, and after investigating all the logic possibilities, i have not clue what this is about.

 

First, there is a room that all the inside walls appear void when looking from outside of it. When i get inside,

the surfaces are rendered, but the place i come from becomes void (black). I removed ALL the visportals from that region.

(From outside)

(From inside- Lighting adjusted)

 

 

Second, a wall used by 2 rooms also becomes invisible, but you can see the inside of the rooms from outside. When inside these

rooms, everything is just fine. Then again, no visportals.

 

Any clues?

 

Thanks!

[Springheel]

Check this thread--it seems like a similar problem and many of the suggestions there might help:

 

http://forums.thedar...ow-thats-a-gap/

[Airship Ballet]

Yep, or the one I started with the same problem:

 

http://forums.thedarkmod.com/topic/16093-disappearing-worldspawn/

 

RJ was really helpful, and following his advice of just being really tidy to begin with has prevented it now. It's a bit restrictive to work off the grid so much but it's a nightmare fixing it.

[Duke Lebowski]

Thanks for the help guys! So i found the solutions to my problem, still i don't know the exact cause.

 

The black room was caused by 4 pillars (worldspawns) i copied and pasted there. I Just created new ones the it didn't cause the glitch.

 

The see-through wall was caused by weird-ass brushes i made to give shapes to my cavern walls. It seems DR really

doesn't like off-grid and weird shaped brushes. These didn't even collided with the wall at all.

 

On an other note, i need an other way of giving curves to my cavern walls. How can i do so without creating weird brushes?

[demagogue]

You almost always want to use patches for curved architecture.

Layer them on top of square brushwork or caulk for sealing if you can.

[Duke Lebowski]

Alirhgt! Thanks