pointfile only shows up when I give the WIP a new name

[JackFarmer]

This is a problem that started out of the blue ca. two (or three?) years ago. At first I thought, there was maybe something broken with my Windows install, but after migrating to Linux, I see the same problem:

1.  I create a map with a leak (or defective portal) and save it  (name, for example: m1)
2.  dmap ,  console shows leak
3. when going back to DR for the pointfile, a message appears stating that there is no pointfile for this map
4. then I save the map with a new name (m2)
5. dmap again
6. back to DR: then there is a pointfile

Anyone has seen this problem as well and if so, is there a fix?

 

[datiswous]

On 11/28/2025 at 7:07 AM, JackFarmer said:

dmap ,  console shows leak

Does it also create a pointfile (lin)?

 

The weird thing I just encountered (but maybe it's normal) is that a dmap only checks for one leak and then stops. In DR you only see this leak, while a second leak is not seen, although it might be there.

Edited November 30 by datiswous