Objectives keep reverting changes

[Springheel]

Is there some trick to editing an objective? I have a particular no-kill objective that is causing me significant frustration.

 

Right now it is set to be on for Hard and Expert. I just want it on Expert. I uncheck the Hard box, hit OK. Load up the objectives and check it again, just be to be sure, and only the Expert box is checked. Good.

 

Save the map, dmap it, load it, and the No Kill is active on Hard. Load up the map in DR, and the Hard box is checked again. WTF? This has already happened three times now. It happened on this same objective with a different detail, though that one eventually stuck.

 

Is there some step to editing an objective that I'm missing?

[Fidcal]

One thing that comes to mind which I've done myself a few times: When you go into edit and set Hard then click OK and go back to the main editor you MUST also click the OK on that main editor page not just close it. I think that final OK is what writes it to the entity.

 

Another thing I've sometimes done but I don't think it applies here is test play the wrong version number, eg, been entering map mymap77 so many times that when I just incremented to mymap78 and saved from DR I still entered map mymap77 out of habit. I have sometimes gone crazy trying to figure out what I'm seeing. Both DR and TDM running. Keep editing and saving mymap78 from DR. Keep pulling up the map mymap77 history and running it in TDM! D'oh!

[Springheel]

When you go into edit and set Hard then click OK and go back to the main editor you MUST also click the OK on that main editor page not just close it. I think that final OK is what writes it to the entity.

 

Hmm, maybe I did that, I don't know. I'll keep it in mind for the future, thanks.